Fatal accident · China
China Southwest IL-18 crash near Chungking
China Southwest Airlines Flight 4146, an Ilyushin IL-18D, crashed near Chungking, Sichuan, China, on January 18, 1988. There were 108 people aboard and all 108 died. The crash was caused by mechanical failure.
This is one of 2 China Southwest Airlines fatal accidents on record. See also all plane crashes in 1988.
Flight 4146 came down before reaching Chongqing
Flight 4146 was a domestic service from Beijing to Chongqing. It crashed near Chungking, Sichuan, about 10 minutes before its scheduled landing. Everyone on board died.
The aircraft was an Ilyushin IL-18D, a four engine turboprop airliner widely used on medium and long domestic routes in that period. On this flight, the accident happened during the final part of the trip, when the crew should have been closing in on the destination.
A fire in the No. 4 engine led to separation and loss of control
The IL-18D suffered a fire in the No. 4 engine, followed by failure of that engine. The pylon and engine then separated from the aircraft. After that, the crew lost control and the aircraft crashed.
The stated cause was mechanical failure. In general, accidents in this category involve a failure of a part or system serious enough to make continued safe flight impossible. Air crash investigators sort those cases by examining the failed components, maintenance history, and the sequence of damage. This crash fits that broad pattern of mechanical failure crashes that begin with a technical fault and then escalate into a control problem.
Loss of control after a major structural or engine event can develop very quickly, especially if the failure changes drag, thrust, or the aircraft's balance. More on that accident type is covered in loss of control in flight.
Maintenance problems were identified
Near Chungking, the chain of failures was traced back to overheating of the feathering oil and poor maintenance procedures. That linked the engine fire and later separation to maintenance rather than weather or collision.
On turboprop aircraft, the feathering system is used to reduce drag from a propeller if an engine fails. If that system overheats or does not work as intended, it can add stress and make an engine emergency harder to contain. In this case, the maintenance findings pointed to the underlying reason the mechanical failure developed into a fatal accident.
Questions people ask about this accident
What happened to China Southwest Airlines Flight 4146?
China Southwest Airlines Flight 4146 crashed near Chungking, Sichuan, China, while flying from Beijing to Chongqing. The aircraft suffered a fire and failure in the No. 4 engine, followed by separation of the pylon and engine and loss of control.
How many people died in the Flight 4146 crash?
There were 108 people aboard and all 108 died. There were no reported fatalities on the ground.
What caused the 1988 China Southwest IL-18 crash?
The crash was caused by mechanical failure. The sequence involved overheating of the feathering oil, poor maintenance procedures, a fire in the No. 4 engine, and separation of the pylon and engine.
What aircraft was involved in the Chungking crash?
The aircraft was an Ilyushin IL-18D, registration B-222. It was operated by China Southwest Airlines.
Related accidents
- 86 killed
- 100 killed
- 83 killed
- 132 killed
- 112 killed
Correct this page or send a photo
Spotted a wrong date, registration or number? Have a photo of the aircraft or the site that you took yourself? Send it here. Nothing is published until an editor has checked it.