Fatal accident · France
Air France Flight 007 overran the runway at Orly
Air France Flight 007, a Boeing B-707-328, crashed at Villeneuve-le-Roi, Val-de-Marne, France, on June 3, 1962. It was departing Paris for New York City with 132 people aboard. The aircraft overran the runway during takeoff and 130 people died. The cause was mechanical failure.
This is one of 73 Air France fatal accidents on record. See also all plane crashes in 1962.
Flight 007 failed to lift off cleanly at Orly
Air France Flight 007 began its takeoff from Orly Airport and the nose came up for about five seconds. It then dropped back onto the runway.
The crew tried to stop. Smoke streamed from the wheels during the braking run, but the Boeing 707 kept going, ran off the runway, struck runway lights, and hit a house at Villeneuve-le-Roi.
This was a classic runway excursion, where an aircraft leaves the paved surface during takeoff or landing. In this case, the excursion followed a failure during the takeoff roll rather than weather or a runway conflict.
A trim servo motor failure left the stabilizer set wrong
The Boeing B-707-328 had an improperly trimmed horizontal stabilizer. That happened because the trim servo motor failed.
With the stabilizer set incorrectly, the aircraft pitched up briefly and then settled back down. The failure was mechanical, not a weather event or a navigation problem.
The horizontal stabilizer helps balance the airplane in pitch. If it is trimmed to the wrong position, the control forces during takeoff can become difficult or impossible to manage. This accident is listed among mechanical failure crashes.
Two stewardesses in the tail survived the impact
The Air France jet carried a large charter group from an art society in Atlanta. Almost all of the victims belonged to that group.
Only two people survived. They were stewardesses seated in the tail section, which broke free in the crash sequence.
No one on the ground was killed. The crash damage included the house the aircraft hit after leaving the runway.
The accident showed how small trim faults could defeat a large jet
Villeneuve-le-Roi became the site of one of the deadliest runway overrun accidents of its time. The aircraft type was a long-range jet airliner used on major international routes, including transatlantic services such as this one.
Early jet transport operations depended on reliable flight control systems and accurate trim settings before takeoff. When a trim system failed, the margin for recovery could disappear in seconds, especially at high speed near the end of the runway.
Later safety work across the industry put heavy attention on flight control reliability, warning logic, maintenance practices, and the way crews verify takeoff configuration before departure.
Questions people ask about this accident
What caused the Air France Flight 007 crash?
The crash was caused by mechanical failure. The aircraft's horizontal stabilizer was improperly trimmed because the trim servo motor failed.
How many people survived Air France Flight 007?
Two people survived. They were two stewardesses seated in the tail section, which broke free in the crash.
Where did Air France Flight 007 crash?
It crashed at Villeneuve-le-Roi, Val-de-Marne, France, after running off the runway during takeoff from Orly Airport.
Was Air France Flight 007 a charter flight?
Almost all of the victims belonged to an art society from Atlanta that had chartered the flight.
Related accidents
- 112 killed
- 109 killed, 4 on the ground
- 95 killed
- 228 killed
- 77 killed
Correct this page or send a photo
Spotted a wrong date, registration or number? Have a photo of the aircraft or the site that you took yourself? Send it here. Nothing is published until an editor has checked it.