Fatal accident · United States
American Airlines Flight 1 crashed in Jamaica Bay
American Airlines Flight 1, a Boeing B-707-123B, crashed into Jamaica Bay, New York, on March 1, 1962, shortly after takeoff from New York for Los Angeles. There were 95 people aboard and all 95 died. Investigators found a mechanical failure in the rudder control system.
This is one of 35 American Airlines fatal accidents on record. See also all plane crashes in 1962.
Flight 1 lost control just after departure
American Airlines Flight 1 departed Idlewild Airport for Los Angeles and climbed to about 1,500 feet. The Boeing then entered a left turn, but the roll did not stop. It continued rolling until it was inverted.
The aircraft crashed into Jamaica Bay, about 3 miles southwest of the control tower. Everyone on board was killed. No one on the ground died.
The roll developed from a rudder control malfunction
The Boeing B-707-123B was found to have had a rudder control malfunction that drove the rudder to a full unwanted deflection. That produced yaw, then sideslip, then a roll the crew could not recover from.
That sequence is one form of loss of control in flight. In swept-wing jet transports, a large unexpected rudder input can quickly upset the aircraft if it happens at low altitude, where there is little time and little height to correct it.
Damage in the rudder servo wiring started at the factory
N7506A was traced back to damage in wiring for the rudder servo unit. Investigators determined that an improper tool had been used at the manufacturing plant when the wiring was wrapped. That damaged the wires and later allowed a short circuit.
The short circuit led to the rudder malfunction that set up the final upset. This accident falls under mechanical failure crashes, but the failure was not a simple part break in service. It began with manufacturing damage that stayed hidden until the flight.
A different explanation was discussed, but not adopted
Jamaica Bay crash reports also mentioned speculation that the captain may have put the aircraft into a steep 45 degree bank and lost control from that maneuver. That was not the accepted explanation for the accident.
The established cause was the rudder control failure and the chain of events that followed it. In accident work, that distinction matters. Discussion can continue around a crash for years, but the accepted finding is the one supported by the evidence and formal analysis of the wreckage and systems.
Questions people ask about this accident
What caused American Airlines Flight 1 to crash in 1962?
The crash was caused by a rudder control malfunction. Investigators found damaged wiring in the rudder servo unit, caused by use of an improper tool during manufacturing, which led to a short circuit and loss of control.
Where did American Airlines Flight 1 crash?
It crashed into Jamaica Bay in New York, New York, about 3 miles southwest of the control tower after departing Idlewild Airport.
How many people were on American Airlines Flight 1?
There were 95 people aboard the flight. All 95 died.
What aircraft was involved in the American Airlines Flight 1 crash?
The aircraft was a Boeing B-707-123B, registration N7506A.
Related accidents
- 260 killed, 5 on the ground
- 92 killed
- 64 killed, 125 on the ground
- 271 killed, 2 on the ground
- 160 killed
Correct this page or send a photo
Spotted a wrong date, registration or number? Have a photo of the aircraft or the site that you took yourself? Send it here. Nothing is published until an editor has checked it.