Fatal accident · Brazil

TAM Flight 402 Fokker 100 crashed after takeoff in Sao Paolo

TAM Flight 402, a Fokker 100, crashed in Sao Paolo, Brazil, on October 31, 1996, shortly after takeoff. There were 95 people aboard and all died. Three people on the ground were also killed. Investigators found a mechanical failure led to loss of control.

This is one of 6 TAM (Brazil) fatal accidents on record. See also all plane crashes in 1996.

Flight 402 came down moments after departure

Flight 402 took off from Sao Paolo for Rio de Janiero and crashed shortly afterward in a residential area. The Fokker 100 struck a building after the crew lost control at low altitude.

Everyone on board the aircraft was killed. The impact and wreckage on the ground also killed three people outside the aircraft. This was a fully occupied airline flight in a densely built part of the city, which left almost no margin for recovery once control was lost.

The Fokker 100 was a short to medium range twin jet used widely on domestic routes. On sectors like this one, the airplane would still be in its initial climb just after departure, with high power set and little height available for troubleshooting or unusual handling problems.

Investigators traced the upset to the right engine thrust reverser

The Fokker 100 involved in Flight 402 suffered an uncommanded deployment of the thrust reverser on the right engine. Investigators concluded that this deployment caused the aircraft to roll to the right and depart controlled flight.

Thrust reversers are intended for use after landing, to help slow the airplane on the runway. In flight, a reverser deploying on one engine creates severe asymmetric drag and thrust. That kind of event can quickly become a loss of control in flight, especially just after takeoff when speed and altitude are still limited.

The accident was classified as a mechanical failure crash. The initiating event was not weather and it was not a runway accident. The critical failure began in the engine system and then developed into a control problem the crew could not overcome.

The protection system moved the lever, but did not explain why

Flight 402 had an automatic protection system intended to respond if a thrust reverser deployed in flight. What it did in this case was bring the throttle lever for the affected engine back to idle.

That action did not tell the pilots what had happened. They received an alarm, but the message only indicated that the auto-throttle was not usable. In the cockpit, that pointed them toward the wrong problem. The crew understood the lever movement as an auto-throttle malfunction and pushed the lever forward again.

They did so with enough force to break the cable. By then the aircraft was already in a dangerous state. The system had reacted to the engine event, but it did not give the crew a clear reason for the throttle movement, and that shaped their response in the seconds available.

Training assumptions left the crew without a practiced response

Sao Paolo was the departure city, but the key issue behind the cockpit response was in the design assumptions made before the flight. Fokker had assessed this scenario as extremely improbable.

Because of that assessment, the airline had not trained pilots for this exact event. The crew therefore faced a rare and confusing failure without a rehearsed procedure that matched what the airplane was doing and what the warning system was showing.

This accident showed a recurring problem in transport aircraft design and operation. A protection feature can work as designed in a narrow technical sense, yet still mislead the crew if the indication is incomplete or points to a different failure. Investigators use that kind of chain, initiating fault, system response, crew interpretation, and aircraft behavior, when determining the cause of an accident. It also illustrates why the wording in a final report matters, and how probable cause can include both a component failure and the way the aircraft and its procedures handled it.

Questions people ask about this accident

What caused TAM Flight 402 to crash?

Investigators found that an uncommanded deployment of the thrust reverser on the right engine caused the aircraft to roll right and lose control. The accident was classified as a mechanical failure.

Where did TAM Flight 402 crash?

TAM Flight 402 crashed in Sao Paolo, Brazil, shortly after takeoff, in a residential area where it struck a building.

How many people died in the TAM Flight 402 crash?

All 95 people aboard the aircraft were killed. Three people on the ground also died.

What aircraft was involved in TAM Flight 402?

The flight was operated by a Fokker 100, registration PT-MRK, flown by TAM (Brazil).

  1. Palair Macedonian Flight 301 crashed after takeoff at Skopje

    Skopje, Macedonia · Fokker 100 · Palair Macedonian · PH-KXL

    83 killed
  2. Air France Airbus A330 crash in the mid-Atlantic on Rio to Paris flight 447

    Atlantic Ocean, near TASIL waypoint · Airbus A330-203 · Air France · F-GZCP

    228 killed
  3. TAM Airbus A320 crash at Congonhas Airport, Sao Paulo, kills 199

    Sao Paulo, Brazil · Airbus A320-233 · TAM Linhas Aereas · PR-MBK

    187 killed, 12 on the ground
  4. Gol Flight 1907 midair collision near Sao Felix do Araguaia

    Near Sao Felix do Araguaia , Brazil · Boeing B-737-8EH /EMB-135JB · Gol Airlines / Private · PR-GTD / N600XL

    154 killed
  5. VASP Flight 168 hit Serra da Aratanha near Pacatuba

    Near Pacatuba, Brazil · Boeing B-727-212A · VASP · PP-SRK

    137 killed

Correct this page or send a photo

Spotted a wrong date, registration or number? Have a photo of the aircraft or the site that you took yourself? Send it here. Nothing is published until an editor has checked it.

By sending a photo you confirm you took it and allow Air Crash DB to publish it with your credit. We keep your message and, if you give them, your name and email, until the correction is handled. See the privacy policy.